3. Quick Start for ROOT RAID
If you use RedHat, see the Howto set up RedHat section in Appendix H. I have not tried this. If you use it successfully, please let me know so I can update this document.
If you don't want to try and build and debug the rescue system, you can get a generic one created from Slackware-3.4 from:
ftp.bizsystems.com/pub/raid/raidboot-0.01.tar.gzPerform the following steps:
- Compile the raid enabled kernel with built in support for your disk subsystem
- Test that the raid array will configure and mount correctly
- Build your OS on the raid system
- Correct the entries in fstab to show /dev/md0 as the root device. Make sure that the partition(s) you use for booting are included in fstab.
- Modify your shutdown halt and reboot script(s) (mine is /etc/rc.d/rc.6) as shown in Modifying the rc-scripts for SHUTDOWN
- Copy the following from you development filesystem
to the rescue system AND the new raid system
cd /root/raidboot mkdir mnt gzip -d rescue.clean losetup /dev/loop0 rescue.clean mount /dev/loop0 mnt copy these files cp -p /etc/* mnt/etc cp -p /etc/rc.d/* mnt/etc/rc.d {or as appropriate for your system} cp -a /lib/modules/* mnt/lib/modules
Some Linux distributions include a test for the ro/rw status of the root file system. The rc startup files need to have this test removed for the initrd rescue system. See the instructions in the section on Correctons for Rescue System.
Create /etc/raidboot.conf which describes the raid boot configuration. This file may NOT contain comments in the first three lines, after that it doesn't matter.
raidboot.conf
/dev/sda1 /dev/sda2 raidboot raid5.conf # comments may only be placed 'after' the three # configuration lines. # # This is '/etc/raidboot.conf' # # line one, the partition(s) containing the 'initrd' raid-rescue system # It is not necessary to boot from these partitions, however, # since the rescue system will not fit on floppy, it is necessary # to know which partitions are to be used to load the rescue system # # line two, the path to the raidboot config information # Where the shutdown status, etc... is located at boot time # It does NOT include the mount point information, only 'path' # /mntpoint/'path' # # line -3-, name of the raid configuration file # Current raid configuration file i.e. raid1.conf, raid5.confA few more things to do and the raid systems is ready to boot.
Create rc.raidown, as described in Appendix F, and copy it to /etc/rc.d on the rescue, development, and raid system. Unmount the rescue system and zip it.
umount mnt losetup -d /dev/loop0 mv rescue.clean rescue gzip rescueCopy the rescue file to the raidboot partitions.
cp rescue.gz /mnt_point(1)/raidboot cp rescue.gz /mnt_point(2)/raidbootActivate the raid array.
mdadd -arSave the good reference status to the raidboot partition
cat /proc/mdstat | grep md0 > /mnt_point(1)/raidboot/raidgood.ref cat /proc/mdstat | grep md0 > /mnt_point(1)/raidboot/raidgood.refLastly, configure the boot program as outlined in Boot Time Configuration Parameters and reboot your system onto the raid array.
Next Previous Contents